Motion Control
Counter v1
Description

Counter v1

This block is obsolete and should not be used.

Please replace all instances of this block with Counter v2 which is functionally identical.
Availability
  • Available only in the dw2xx-v2 series products
  • Requires library: Precision Motion (option -39)
  • Firmware versions 0x2107 through 0x210B
savvy-SFD Graphic encFreqCounter
Graphic with Parameters encFreqCounter

Parameters

Count Input, Read-only, Placeholder (special (count & timestamp))
Hold Input, Read-write, Boolean (signed 16-bit integer)

Counter v1

This block is obsolete and should not be used.

Please replace all instances of this block with Counter v2 which is functionally identical.


0 = Inactive
1 = Hold
Set Zero Input, Read-write, Boolean (signed 16-bit integer)

Counter v1

This block is obsolete and should not be used.

Please replace all instances of this block with Counter v2 which is functionally identical.


0 = Inactive
1 = Set
Output Output, Read-only, Analog (32-bit IEEE-754 floating point value)
-340E36 to 340E36

Counter v1

This block is obsolete and should not be used.

Please replace all instances of this block with Counter v2 which is functionally identical.
Status Internal Parameter, Read-only, Boolean (signed 16-bit integer)

Counter v1

This block is obsolete and should not be used.

Please replace all instances of this block with Counter v2 which is functionally identical.


0 = OK
1 = Fault