I/O
T23 Digital Output
Description Range: +24V to 0V

Output can be set to Source or Sink based on the type of input connected to the terminal. Set Input HIGH (1) to put Volts on to output terminal.
Availability
  • Available only in the dw2xx series products
  • Requires library: System & I/O
  • Requires: Analog and Digital I/O
  • Singleton function block
  • Firmware versions 0x2000 and later
savvy-SFD Graphic dopT23
Graphic with Parameters dopT23

Parameters

Input Input, Read-write, Boolean (signed 16-bit integer)
0 = Low
1 = High
Source Enable Input, Read-write, Boolean (signed 16-bit integer)
0 = Disable
1 = Enable
Sink Enable Input, Read-write, Boolean (signed 16-bit integer)
0 = Disable
1 = Enable
Source Status Internal Parameter, Read-write, Enumerated (signed 16-bit integer)

Warning: resetting a fault will momentarily reset the entire I/O subsytem.
0 = Reset
1 = OK
2 = Fault