Motion Control
Cyclic Position v1
Description

Cyclic Position v1

This block is obsolete and should not be used.

Please replace all instances of this block with Cyclic Position v2 which is functionally identical.
Availability
  • Available only in the dw2xx-v2 series products
  • Requires library: Precision Motion (option -39)
  • Firmware versions 0x2105 through 0x210B
savvy-SFD Graphic cycPos
Graphic with Parameters cycPos

Parameters

Count Input, Read-only, Placeholder (special (count & timestamp))
Hold Input, Read-write, Boolean (signed 16-bit integer)

Cyclic Position v1

This block is obsolete and should not be used.

Please replace all instances of this block with Cyclic Position v2 which is functionally identical.


0 = Inactive
1 = Hold
Set Zero Input, Read-write, Boolean (signed 16-bit integer)

Cyclic Position v1

This block is obsolete and should not be used.

Please replace all instances of this block with Cyclic Position v2 which is functionally identical.


0 = Disabled
1 = Enabled
Set Length Input, Read-write, Boolean (signed 16-bit integer)

Cyclic Position v1

This block is obsolete and should not be used.

Please replace all instances of this block with Cyclic Position v2 which is functionally identical.


0 = Disabled
1 = Enabled
Output Output, Read-only, Analog (32-bit IEEE-754 floating point value)
0.0000 to 1.0000

Cyclic Position v1

This block is obsolete and should not be used.

Please replace all instances of this block with Cyclic Position v2 which is functionally identical.
Cycle Length Internal Parameter, Read-write, Analog (32-bit IEEE-754 floating point value)
-340E36 pulses to 340E36 pulses

Cyclic Position v1

This block is obsolete and should not be used.

Please replace all instances of this block with Cyclic Position v2 which is functionally identical.
Status Internal Parameter, Read-only, Boolean (signed 16-bit integer)

Cyclic Position v1

This block is obsolete and should not be used.

Please replace all instances of this block with Cyclic Position v2 which is functionally identical.


0 = OK
1 = Fault
Internal Count Internal Parameter, Read-only, Analog (32-bit IEEE-754 floating point value)
-340E36 pulses to 340E36 pulses